BMC G2S BPAP Series Quick Operation Manual

G2S BPAP Series Quick Operation Manual V2.0
1 / 2
G2S BPAP Series Quick Operation Manual
1. Button Functions
Ramp Button: Press it to enable the Ramp feature
Mute Button: Press it to mute the alarms
Knob: Start treatment and adjust device settings
2. Setting up the Device
C
Tube
B
Filter Cap (Air Inlet)
Air Outlet
Device
Power Cord
Power Outlet
DC Inlet
Power Adapter
A
D
Mask
E
A. Connect one end of the tube to the assembled mask.
B. Connect the other end of the tube securely to the air outlet of the device, as shown in the figure
above.
C. Connect the power adapter to the DC inlet of the main device.
D. Connect the power cord to the power adapter.
E. Plug the power cord into the power outlet.
3. Adjusting Device Settings
A. After the device is connected to power, its screen displays the Main Interface shown in the first
figure below, or the Main Interface shown in the second figure below, or the Main Interface shown
in the third figure below, or the Main Interface shown in the fourth figure below.
Note: The value of blood oxygen saturation (SpO
2
) and pulse rate can only be seen after the SpO
2
Kit is
connected to the main device correctly.
The above interface
only applies to G2S
B20S, G2S B20A.
The above interface
only applies to G2S
B20T.
The above interface only
applies to G2S B25A,
G2S B25S.
The above interface only
applies to G2S B25T, G2S
B25VT, G2S B30T, G2S
B30VT, G2S B30AT and
G2S LAB.

BMC G2S BPAP Series Specifications

General

Brand	BMC
Model	G2S BPAP Series
Category	Medical Equipment
Language	English