Headlamps
1 Parking lamps / daytime running lights
2 Low beams/high beams/headlamp flasher
3 Turn signal
Low beams and high beams are designed with
xenon technology.
The parking lamps and daylight running lights
are made using LED technology.
Contact your service center in the event of a
malfunction.
Turn signal
Follow the general instructions on lamps and
bulbs, refer to page 183.
21-watt bulb, PY21W
1. In the wheel house, loosen the two brack‐
ets and remove the cover.
2. If necessary, pull the inside trim of the
wheel house slightly inward. Turn the bulb
holder counterclockwise and remove.
3. Press the bulb gently into the socket, turn
counterclockwise and remove.
4. Install the new bulb and the bulb holder in
reverse order of removal.
5. Attach the cover to the wheel house.
Front fog lamps
Follow the general instructions on lamps and
bulbs, refer to page 183.
35-watt bulb, H8.
1.
Use the back side of the screwdriver from
the onboard vehicle tool kit to remove the
three wheel house panel screws, arrow 1.
Seite 187
Replacing components Mobility
187
Online Edition for Part no. 01 40 2 924 974 - X/13
To Next Page
Loading...
Need help?
General
