EasyManuals Logo
Home>BMW>Automobile>2006 6 Series

BMW 2006 6 Series User Manual

BMW 2006 6 Series
236 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #194 background imageLoading...
Page #194 background image
Mobility
193
Reference At a glanceControlsDriving tipsCommunications NavigationEntertainment
You can also call BMW of North America at
1-800-831-1117 or visit the website at
www.bmwusa.com to obtain this information.
Do not use oil additives; under some
circumstances, they can harm your
engine.<
Viscosity grades
The viscosity is a measure of the thickness of
the oil and is specified in SAE grades.
The choice of the right SAE grade is based on
the climatic conditions in the region in which
you normally drive your BMW.
Approved oils belong to the SAE grades
5W-40 and 5W-30.<
These oils can be used for driving at all outside
temperatures.
Coolant
Do not open the cooling system when the
engine is hot. Escaping coolant can cause
burns.<
Coolant consists of water and coolant additive.
Not all commercially available additives are suit-
able for your BMW. Ask your BMW center for
suitable additives.
Only use suitable additives; otherwise,
engine damage may result. The additives
present a health hazard.<
Always observe all applicable environ-
mental laws and regulations when dis-
posing of used coolant additives.<
Checking coolant level
1. The engine must be at ambient tempera-
ture.
2. Turn the cap of the expansion tank counter-
clockwise to allow any accumulated pres-
sure to escape, then continue turning to
open.
3. The coolant level is correct when it lies
between the Min and Max mark, also refer to
the drawing next the filler neck.
4. If the coolant is low, slowly add coolant up to
the specified level – do not overfill.
5. Turn the cap until it clicks.
6. Have the reason for the coolant loss elimi-
nated as soon as possible.
Brake system
Malfunction
Brake fluid
The warning lamp lights up in red
in spite of the handbrake being
released; a message appears on the
Control Display.
Stop the vehicle immediately.
The brake fluid in the reservoir has fallen to
below the minimum level. At the same time, a
significantly longer brake pedal path may be
noticeable. Have the system checked immedi-
ately by a BMW center.
Warning lamp for Canadian models.
Online Edition for Part-No. 01 41 0 159 709 © 09/05 BMW AG

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the BMW 2006 6 Series and is the answer not in the manual?

BMW 2006 6 Series Specifications

General IconGeneral
BrandBMW
Model2006 6 Series
CategoryAutomobile
LanguageEnglish

Related product manuals