Controls
45
Reference At a glanceDriving tipsCommunications NavigationEntertainmentMobility
Seat, mirror and steering
wheel memory
You can store and select three different adjust-
ment settings for the driver's seat, exterior mir-
rors and steering wheel.
The adjustments of the lumbar support and the
backrest width are not stored in the memory.
Storing
1. Switch on radio readiness or ignition, refer
to page 55.
2. Set the desired seat, exterior mirror and
steering wheel positions.
3. Press the button:
The LED in the button lights up.
4. Press the desired memory button 1, 2 or 3:
The LED goes out.
Requesting
Do not request a position from the mem-
ory while the vehicle is moving. There is a
risk of accident from unexpected movement of
the seat or steering wheel.<
Comfort mode
1. Open the driver's door after unlocking or
switch on radio readiness, refer to page 55.
2. Briefly press the desired memory button 1,
2 or 3.
The system cancels the adjustment procedure
when you briefly press one of the seat adjust-
ment switches or one of the memory buttons.
The adjusting procedure for the steering wheel
is interrupted if you briefly press the switch for
the steering wheel adjustment in any direction,
refer to page 50.
Safety feature
1. Close the driver's door and switch ignition
on or off, refer to page 55.
2. Press the desired memory button 1, 2 or 3
and maintain pressure until the adjustment
process has been completed.
If the button was pressed inadvertently:
press the button again; the LED goes out.
Requesting with remote control
The last positions of the driver's seat, external
rearview mirrors, and steering wheel are stored
for the remote key currently in use.
You can select
*
when the position is requested.
> Request when unlocking vehicle
> Request when opening driver's door. In the
Convertible, only this function is used.
When using this feature, always make
sure that the footwell behind the driver's
seat is empty and unobstructed. Failure to do
so could cause injury to persons or damage to
objects behind the seat as a result of a rearward
movement of the seat.<
The system cancels the adjustment procedure
when you briefly press one of the seat adjust-
ment switches or one of the memory buttons.
Selecting automatic call-up
iDrive, for operating principle refer to page 16.
1. "Settings"
2. "Door locks"
3. "Last seat position auto."
Online Edition for Part no. 01 41 2 602 735 - © 08/09 BMW AGOnline Edition for Part no. 01 41 2 602 735 - © 08/09 BMW AG
To Next Page
Loading...
Need help?
General
