1. Close all doors.
2. Slide the switch forwards beyond the resist‐
ance point and hold it in this position.
The Glass Roof is closed with limited anti-
trap function. If the closing force exceeds a
certain level, the closing operation is interrup‐
ted.
3. Press the switch forwards once again beyond
the resistance point and hold until the Glass
Roof closes with no anti-trap function. Ensure
that the closing area is clear.
Closing without the anti-trap
mechanism from a raised position
In the event of danger, proceed as follows:
1.
Close all doors.
2. Slide the switch forwards beyond the resist‐
ance point and hold it in this position.
The Glass Roof is closed with no anti-trap func‐
tion.
Initialising after a power failure
General
If a power failure occurs while the Glass Roof is
opening or closing, it may only have limited func‐
tionality afterwards.
The system can be initialised under the following
conditions.
▷ The vehicle is parked on level ground.
▷ In drive-ready state.
▷ The outside temperature is above 5 ℃/41 ℉.
During initialisation, the Glass Roof closes with
no antitrap mechanism.
Ensure that the closing area is clear.
Initialising the system
Press the switch up and hold until
initialisation is complete:
Initialisation begins within 15 seconds.
▷ If the Glass Roof is closed, it opens, then
closes again.
▷ If the Glass Roof is open, it first closes, then
opens and closes again.
Initialisation is complete once the Glass Roof and
sun guard have opened then closed again.
Seite 114
CONTROLS
Opening and closing
114
Online Edition for Part no. xxx - VI/19
To Next Page
Loading...
Need help?
General
