95n
OverviewControlsMaintenanceRepairsDataIndex
Computer in the MID*
After three incorrect code entries, or
three attempts to start the engine
without a code entry, the alarm will
sound for 30 seconds on vehicles
equipped with an alarm.
Deactivating the alarm in an emer-
gency:
If you have forgotten the code, proceed
as follows:
1. Disconnect the battery, wait approx.
2 minutes, then reconnect it. Note
that on vehicles with an alarm, this
will sound
2. Set the ignition key to position 1:
The time display will count down for
the next ten minutes
3. After ten minutes, start the engine.
If the code becomes available
again in the meantime, it can be
entered during the waiting period after
pressing the CODE button.<
Remote control
The button on the turn signal indicator
lever can be used to select the
computer data which are to be
displayed.
To do this, press
> the button on the lever until PROG 1
shows on the display
> the MID buttons in the order in which
you wish the information to be
displayed.
Each time an entry is stored, the
program number appears on the
display.
To terminate the selection procedure:
Press the right side of the button.
390de700
To have all the available information
displayed, press
> the button on the lever until the
display shows PROG 1
> the SET button.
To obtain individual items of informa-
tion, press the button briefly as often as
necessary.
To Next Page
Loading...
Need help?
General
