modify the oil service
i
nterval
(programming/encoding,
all and E7x without
CAS)
Or:
00 62 974 Refer to KSD2
Performed with labor
operation 00 62 118:
Check and replace the
timing chain (includes
removing and installing
cylinder head), change
engine oil and filter and
modify the oil service
interval
(programming/encoding,
E7x with CAS only)
And:
When other additional work and/or parts are required as a direct result of this issue, including the applicable
labor operations listed in KSD2, claim these items under the defect code listed above.
And:
Sublet – Materials
Sublet Code 4
S
ee sublet
reimbursement
calculation below
Reimbursement for used quantities
of required operating fluids,
including engine oil (applicable
BMW part numbers. Do not use
these part numbers for claim
submission)
Sublet calculation:
Reimbursement for used quantities of required operating fluids, including engine oil (applicable BMW part
numbers) at dealer net plus handling.
Enter the material cost in sublet and itemize the amount in the claim comment section.
Vehicle Programming/Encoding
Programming and encoding includes performing a “Vehicle test” (with vehicle diagnosis system – checking
faults) and connecting an approved battery charger/power supply to the vehicle.
If a vehicle control module or component was working properly and/or had no related faults stored prior to
vehicle programming and it fails to program correctly and/or requires initialization, this additional work must
be claimed with separate labor operations under the defect code listed above; refer to KSD2.
Repairs to address control modules and/or components with pre-existing conditions are not eligible to be
claimed under the defect code listed in this bulletin.
https://www.bmwtis.net/tiscode/cgi
bin/bulletin.aspx?sie_path=/tsb/bulletins/htm_store/235
To Next Page
Loading...
Need help?
General
