7
Power Output (RMS)
C10: 10W
C20: 20W
Distortion Less than 1% @ Rated Power Output
Frequency Response 70 Hz - 16 kHz (±1 dB)
Hum and Noise (20 Hz to 20 kHz)
MIC Input: 55 dB below rated output
AUX Input: 70 dB below rated output
TEL Input: 70 dB below rated output
Input Sensitivity
MIC Lo-Z Balanced: 600 µV
AUX: 85 mV
TEL: 75 mV
Outputs 4, 8, 16 ohms, 25V, and 70V
Output Connections: Screw terminal strip
Input Connections:
MIC/TEL: Lo-Z screw terminals
AUX: RCA jack
Controls: MIC1, MIC2/AUX (switch selected), TREBLE, VOX, TEL
Tone Control: TREBLE: -10 dB to 0 dB @ 10 kHz
Power Requirements: 120V AC, 60 Hz
C10: 38W
C20: 50W
Dimensions: 11-3/8" W x 2-7/8" H x 7-3/8" D (both models)
Product Weight
C10: 5 lb.
C20: 6 lb.
Technical Specifications
Accessories
WMT1A - Line-Matching Transformer
• Hi-Z, 10k-ohm primary impedance
• Lo-Z, 600-ohm secondary impedance, balanced with center tap
• Matches high-impedance unbalanced or low-impedance balanced signals
• Jumper selection allows line level signal to microphone level signal conversion
RPK35B - Rack Panel Kit
• RPK35B adapts Classic Series amps (Models C10, and C20) for 19" rack mounting, 2 rack spaces (3-1/2")
• Heavy gauge steel construction
WMK1 - In-Wall Mounting Kit
• Cabinet fits between standard 2 x 4’s on standard 16"
• Controls are accessible via a tilt-open door
• Heavy gauge steel construction
To Next Page
Loading...
Need help?
General
