25
Electrical
connection
Only connect the dryer to an earth contact
socket installed in accordance with
regulations.
Make sure that the voltage details on the rating
plate (visible when the door is open)
correspond with the mains voltage where the
appliance is set up. The connected load and
the fuse or LS machine are also specified on
the rating plate.
Make sure that the plug and the socket match,
the cross section of the cable is sufficient and
the earthing system has been installed in
accordance with regulations.
Do not use multiple plugs/couplings or an
extension cable.
Only pull the mains plug out of the socket
using the grip on the plug. Do not use wet
hands to connect the appliance to the mains.
Only have the mains cable replaced by the
after-sales service.
If the power cable for the dryer is damaged,
have it replaced by the manufacturer or its
after-sales service.
To Next Page
Loading...
Need help?
General