TIPS ABOUT INDICATOR PANEL
The indicator panel will change each time you
press the DISPLAY button in the following man-
ner.
NOTE:
• The displayed temperatures are rough estimates and
may vary from the actual temperatures.
•
is displayed until the temperatures are being
detected.
• Only the room temperature can be displayed for 5
seconds when the unit is not in operation.
• During SELF CLEAN operation, the indicator panel
will display remaining time of the operation. Room
and outdoor temperature will not be displayed even if
you press the DISPLAY button.
• Temperature display ranges
Room temperature
Temperature Indicator Room temperature
Above 40˚C
0˚C~40˚C
Below 0˚C
Outdoor temperature
Temperature Indicator Outdoor temperature
Above 45˚C
-19˚C~45˚C
-25˚C~-20˚C
Below -25˚C
*The minus symbol "
-
" is not displayed.
Outdoor Temp.Lamp lights up
The room
temperature is
displayed
.
The outdoor
temperature is
displayed.
No display.
Display button
The blue PLASMACLUSTER lamp and
the green FULL POWER lamp will also
go off.
In this operation, the air conditioner works at the
maximum power to makes the room cool or warm
rapidly.
1
Press the FULL POWER button during
operation.
• The remote control will display “ ”.
• The temperature display will go off.
• The green FULL POWER lamp (
) on
the unit will light up.
TO CANCEL
Press the FULL POWER button again.
• The green FULL POWER lamp ( ) on the unit
will turn off.
NOTE:
• You can not set the temperature or fan speed during
the FULL POWER operation.
• FULL POWER operation will be automatically
cancelled in one hour, and the unit return to the
original settings. The green FULL POWER lamp
(
) on the unit will turn off.
FULL POWER OPERATION
1
*
EHP6.5_AA_multi_TINSEA825JBRZ.indd 7 2013/7/6 13:35:33
To Next Page
Loading...
Need help?
General
