14
en Overview
Overview
X Fig. A
Base unit
1 Power cord
2 Ejector button
For removing the tools.
3 Switch
For switching the appliance on and off
and adjusting the operating speed.
0 = switched off
1 = lowest speed
5 = highest speed
M = instantaneous switching (highest
4 Apertures for inserting the tools
5 Release buttons
For removing accessories from
the rear aperture. Press both buttons
simultaneously.
6 Rear aperture with lock
For inserting accessories, e.g. the high-
speed hand blender.
Tools
7 Stirring whisks
8 Kneading hooks
Accessories
On some models
9 High-speed hand blender
10 Blender jug with lid
11 Universal cutter
If an accessory is not supplied as standard,
it can be ordered from customer service.
Operation
Before using the appliance for the first
time, clean the base unit and tools.
Always unwind the power cord
completely.
Important note: When the rear aperture
is open, the appliance can be operated
using instantaneous switching only. Selector
switch 1-5 will not function. Open and close
the lock on the rear aperture only when
the switch is in position 0.
Always observe the maximum quantities
and processing times in the table.
X Fig. D
Base unit with tools
Beating whisks
The beating whisks can be used to whisk
egg whites or beat cream. They can also
be used to make light dough, e.g. sponge
mixture, cake mixture, pancake batter.
They should not be used to make mayon-
naise. To make mayonnaise, use the high-
speed hand blender.
Kneading hooks
The kneading hooks can be used to make
different types of dough, e.g yeast dough,
dough for pizzas or bread, pastry for strudel
or shortcrust pastry.
The maximum processing quantity is
500 g flour and ingredients.
X Fig. B
1. Insert the required pair of tools in the
apertures and press on the tools until
they engage.
a. Note the shape of the plastic parts
on the tools to avoid mixing them
up.
b. Insert tools one after the other to
stop them from getting caught!
2. Insert the mains plug.
3. Insert the tools in the receptacle and
switch the appliance on at the required
level.
– Level 1, 2: for working in and mixing in.
– Level 3, 4, 5: for kneading and beating.
– Instantaneous switching M: for mixing
or beating ingredients quickly.
4. Move the mixer to and fro in the bowl
while mixing. Never reach into the
rotating tools.
5. As soon as the desired consistency is
achieved, set the switch to 0 and wait
for the appliance to come to a standstill.
6. Pull out the mains plug.
7. Release and remove the tools by press-
ing the ejector button. The ejector button
cannot be actuated unless the switch is
in the 0 position.
To Next Page
Need help?
General
Weight and Dimensions
