English - 1
1 Auxiliary handle
2 On/Off switch
3 Thumb wheel for oscillating rate selection
(PSS 28 AE)
4 Lock-on button for On/Off switch
5 Dust box (micro filtersystem)
6 Extraction adapter
7 Clamping lever
8 Sanding plate
9 Sanding sheet (without Velcro attachment)*
10 Sanding sheet (Velcro attachment)*
11 Outlet piece
12 Latching lever
13 Filter element (micro filtersystem)
14 Reducer
15 Hole punching tool
* Accessory
* Not all of the accessories illustrated or described are
included as standard delivery.
Measured values determined according to
EN 50 144.
Typically the A-weighted sound pressure level of
the product is 79 dB (A).
The noise level when working can exceed
85 dB (A).
Wear ear protection!
The typical weighted acceleration is 5 m/s
2
.
The machine is intended for the dry sanding of
surfaces of wood, plastic and filler as well as for
painter surfaces.
Working safely with this ma-
chine is possible only when the
operating and safety information
are read completely and the in-
structions contained therein are
strictly followed. In addition, the
general safety notes in the enclosed booklet
must be observed.
■ Wear safety goggles.
■ The dust that is produced while working can be
detrimental to health, inflammable or explo-
sive. Suitable safety measures are required.
Examples: Some dusts are regarded as carci-
nogenic. Use suitable dust/chip extraction and
wear a dust respirator.
Dust from light alloys can burn or explode. Al-
ways keep the work place clean, as blends of
materials are particularly dangerous.
■ If the mains cable is damaged or cut through
while working, do not touch the cable but im-
mediately pull the mains plug. Never use the
machine with a damaged cable.
■ Connect machines that are used in the open
via a residual current device (RCD) with an ac-
tuating current of 30 mA maximum. Use only
extension cables that are approved for outdoor
use.
■ The machine can be used only for dry sanding.
■ Insert the mains plug only when the machine is
switched off.
■ Always direct the cable to the rear away from
the machine.
■ Do not work with materials containing asbes-
tos.
Tool Specifications
Orbital sander PSS 28 A PSS 28 AE
Order number 0 603 285 2.. 0 603 285 5..
Rated power [W] 250 250
Output power [W] 110 110
Oscillating Rate Selection – •
Oscillations [opm] 20 000 14 000– 20 000
No-load speed [rpm] 10 000 7 000– 10 000
Oscillation range-Ø [mm] 2.4 2.4
Sanding sheet:
-Velcro attachment [mm] 115 x 230 115 x 230
-Clamping attachment [mm] 115 x 280 115 x 280
Weight (without accessories) approx. [kg] 2.0 2.0
Protection class / II / II
Machine Elements
Noise/Vibration Information
Intended Use
For Your Safety
7 • 2 609 932 012 • TMS • 17.12.01
To Next Page
Loading...
Need help?
General
