Programming the BOSCH Solution 2000 & 3000 with the Icon
Keypad
This programming guide will show you the simplest steps required to program the basic
features of the system in order to make it operational for domestic use. Each programming
method assumes that you are not in programming mode, and that the system is in its
normal state and disarmed.
Press the button sequences inside the [ square brackets ] to complete the task at each
step in the method.
• Installer Code (default) = 1 2 3 4 (use this code to enter programming mode).
• User 1 Code (default) = 2 5 8 0 (this is also a master code).
Most of the required programming uses the following four-step method:
1. Enter programming mode: [ 1 2 3 4 # ] — two beeps sound and the Stay (person
inside house) and Away (person outside house) indicators flash on the keypad.
2. Go to the required location: [ loc. no. ] [ # ]
3. Change the data in that location (i.e., enter a number between 0 - 15), e.g.: [ 1 5 * ]
4. Save and exit programming mode: [ 9 6 0 # ] — or move to another location to make
more changes.
The alarm system stores information related to each feature at unique “locations”. Each
location will store a number between 0 - 15 that will indicate the option(s) selected for that
particular feature. Depending on the type of feature, the stored number may literally
represent the actual number (e.g., a number 1 may literally mean the number 1, which
will be the case for a user code location), or it may represent a specific function (e.g., a 1
may indicate that something is activated, selected, or turned on, which is the case for the
RF receiver location, where 1 means the RADION receiver has been set). Some
locations will require that you combine numbers to select multiple options. For example, if
option 1 means “Reporting functions allowed” and option 2 means “Remote arming by
telephone allowed”, then entering the number 3 at that location would select both of those
options, since 1 + 2 = 3.
Apart from programming mode, some settings can be programmed quickly via installer
code / master code operations, which require you to enter the code, followed by a
number representing the required operation, and then pressing [ # ] to confirm — three
beeps will sound and the Stay (person inside house) and Away (person outside house)
indicators flash on the keypad. For an example of this, please refer to “XV. Set Date &
Time.”
Page 1! of 12!
To Next Page
Need help?
General
