EasyManuals Logo
Home>Bose>Speakers>151

Bose 151 Service Manual

Bose 151
10 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #2 background imageLoading...
Page #2 background image
Test Procedures
NOTES: In each test procedure, it is necessary to remove the grille to access the driver.
Refer to the Grille Removal procedure.
Polarities are not marked on the input terminals of the 151™ speaker. The red terminal is
the positive (+) terminal and the black terminal is the negative (-) terminal. See Figure 1.
1. Rub and Tick Test
A. Connect a sine wave oscillator to a power amplifier. Adjust the frequency of the oscillator
to 10 Hz and the amplifier output to 6 Vrms. Connect the amplifier output to the input
terminals of the 151 speaker (see Figure 1). No extraneous noises such as rubbing,
scraping or ticking should be heard.
NOTE: To distinguish between normal suspension noise and rubs or ticks, displace the
cone on the driver slightly with your fingers. If the noise can be made to go away or get
worse, it is a rub or a tick and the driver should be replaced. If the noise stays the same, it
is normal suspension noise and the driver is fine. Suspension noises will not be heard with
program material.
2. Sweep Test
A. Sweep the oscillator from 10 Hz to 3 kHz using the 6 Vrms signal. There should not be
any loud extraneous sounds. (Note: A "whooshing" noise from the port at approximately 80
Hz is acceptable). If there are any loud buzzes or distortion, replace the driver. (See
Disassembly/Assembly Procedures for instructions on replacing the driver).
NOTE: There should not be any buzzes or rattles from within the speaker cabinet. Redress
any wire or component that buzzes.
B. Reduce the amplifier output to 3 Vrms and continue sweeping from 3 kHz to 15 kHz. If
there is any buzzing or distorting,replace the driver (see Disassembly/Assembly
Procedures for instructions on replacing the driver).
1

Other manuals for Bose 151

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bose 151 and is the answer not in the manual?

Bose 151 Specifications

General IconGeneral
TypeIn-wall/On-wall/In-ceiling speakers
Dimensions (WxDxH)318 x 152 x 114 mm
Speaker type2-way
Tweeter diameter64 mm
Audio output channels2.0 channels
RMS rated power- W
Product colorWhite
Package weight5100 g
Weight and Dimensions IconWeight and Dimensions
Weight4300 g

Related product manuals