Installers Guide to the Bose® Serial interface June 28, 2011
Bose Confidential Information Page 30/42 Do Not Redistribute
Client sends: 05 00 01 49 4d
Table 6-17 Query Tuner Station Command Format
The total number of bytes in this packet is 5
All Status bits must be zero for packets sent by the Client
The OpCode of the Query Tuner Station command
The exclusive or (XOR) of all bytes in this packet (including
length) that precede the checksum byte
Console Responds: 06 <Status> 01 49 <Station>
Table 6-18 Query Tuner Station Response Format
The total number of bytes in this packet is 6
Error bit = 0, Notification bit = 0
The OpCode of the Query Tuner Station command
The value of the Station number. The Least significant byte
is first, followed by the most significant byte. See the
calculation in Section 6.6.1 Converting between frequency
and station to convert a Station number to a frequency.
6.6.1 Converting between frequency and station number
The commands to control and query the tuner use station number rather than station frequency
as parameters. There are also three tuner regions: USA, Europe, and Japan.
To convert between the two values use these values and formulas:
Table 6-19 Converting between frequency and station number
To Next Page
Loading...
Need help?
General
