Bose Aviation Headset X User Manual

14
G
ETTING YOUR HEADSET READY FOR USE
Inserting batteries
Insert the two supplied alkaline AA batteries (IEC LR6) into the
control module (Figure 10).
Figure 10
Installing the two batteries
+
CAUTION: The battery compartment is designed to prevent inadvertent
reverse polarity from installing the batteries incorrectly. If the batteries do
not
seem to fit correctly, do not force them in. Forcing an improper connec-
tion will cause permanent damage to the control module.
Preparing the aircraft powered headset for use
For permanent installation of the headset, the harness (material
number 323172-0010) is installed into the aircraft. The 3-foot
wiring harness includes a self-latching, pr
ecision designed, quick-
connector for panel mounting in the aircraft. The connector is
mechanically keyed to ensure proper mating. To order additional
harnesses, call Bose at 1-800-242-9008.
Note: The aircraft panel connector must be mounted and docu-
mented by qualified personnel to pe
rform this type of avionics
installation into the aircraft being used. Co
nsult your local FAA office
or aviation authorities to determine the appropriate documentation
required.
The Bose connector (material number 323172-0010) is TSO
appr
oved (C-57a and C-58a) together with the Bose Series II
Aviation Headset and the Bose Aviation Headset X.
Attaching and removing the cable
When the quick-connector is installed, the cable leading from the
control module connects to it. Match the narrow bar on the cable
end to the slot on the connector. Press in until the two parts engage
(Figure 11 on page 15).
To release the cable, pull back on the sleeve near the end of the
ca
ble. Then gently remove the cable from the connector.
00_AM270261-01_HeadsetXII.book Page 14 Tuesday, August 11, 2009 2:27 PM

Bose Aviation Headset X Specifications

General

Brand	Bose
Model	Aviation Headset X
Category	Headsets
Language	English