4.3 Room Combining
4. PRIVILEGED USER SOFTWARE
This module can be used to activate up to 40 Room Combining presets. All programmed presets will be
listed in the status display (the lowest display in the picture below). To activate: Click on one of the listed
presets. A highlighted preset indicates that these are active at the moment. When a red indicator is shown
in front of a preset, one can not (de-)activate this preset (User disabled or blocked due to room overlap).
One is able to configure 10 of the 40 Room Combining presets and the user ability to control these on the
AMS-8 system rack. All other Room Combining presets can only be configured by your system installer.
Settings button (Pin-code protected)
Button to open all modules (Paging panel & Presets/Events, only available in Multi User Mode)
Preset select: Press this button (at the left) to (de-)activate another preset
4.4 Event Scheduler
This module can be used to activate up to 40 events from the Event Scheduler. All programmed events
will be listed in the status display (the lowest display in the picture below). To activate: Click on one of
the listed events. A highlighted event indicates that these are active at the moment. When a red indicator
is shown in front of an event, one can not (de-)activate this event (User disabled or blocked due to room
overlap). The user is able to configure 10 of the 40 events and the user ability to control these on the
AMS-8 system rack. All other events can only be configured by your system installer.
Settings button (Pin-code protected)
Button to open all modules (Paging panel & Presets/Events, only available in Multi User Mode)
Preset select: Press this button (at the left) to (de-)activate another preset
To Next Page
Loading...
Need help?
General
