7
THEORY OF OPERATION
The following discussion references the Main PCB Schematic and Block Diagram. The
schematic is located in the back of this manual and the block diagram is shown in Figure 3.
GENERAL
The FreeSpace™business music system electronics module powers the FreeSpace loud-
speaker system,which is a derivative of the AM-5
®
powered loudspeaker system. As a powered
system, FreeSpace is meant to be used in conjunction with the customer's audio source.
The FreeSpace system offers the following features:
- Automatic turn-on/ turn-off (audio sense or signal from the customer's audio source)
- Automatic (Bose
®
patented) dynamic equalization
- Bi-amplification for better power distribution to speakers
- High Efficiency Class G Power Amp stages (100W + 50W +50W)
- Active equalization for smoother frequency response
- Amplifier short-circuit protection
- Bass/treble room compensation controls
- Differential input stage (to reject hum)
- Dynamic compressor to prevent amplifier output overload distortion
- Electronic remote volume
BLOCK DIAGRAM DESCRIPTION
Refer to the block diagram and schematic mentioned above. For discussion of L/R channels,
only the right channel is discussed. Left channel operation is identical.
1. Power Supply
Two power supplies are used in the FreeSpace system. One is a low power regulated ±15VDC
supply used to power the signal processing circuitry, the other is the high voltage main power
supply used to power the three Class G power amplifier stages. Two voltages are provided for
class G operation, ±20VDC and ±40VDC. The regulated ±15VDC supply always remains
energized as long as the unit is wired to an active mains voltage source. The main power
amplifier supply is turned on and off by the audio sensing circuit (discussed elsewhere).
To Next Page
Loading...
Need help?
General
