Bose FreeSpace FS4CE User Manual

8 • English FreeSpace FS4CE • Installation Guide
PRO.BOSE.COM
Installation
Mounting the Loudspeaker
1. Pass the audio wire through the wire opening and through the input cover (not shown; see Preparing the Input Cover
on page 5).
2. Wire the connector and insert the connector into the loudspeaker. Tighten the conduit fitting if applicable. For wiring
information, see Wiring the Loudspeaker on page6.
3. Insert the loudspeaker through the hole and into the tile bridge or rough-in pan (see page 7) and turn
(counterclockwise) the anchor arm screws one half turn to release the anchor arms. Slowly lower the loudspeaker until
the anchor arms engage on the tile bridge or rough-in pan.
4. Tighten the anchor arm screws to secure the loudspeaker.
WARNING: Over-tightening or over-loosening the screws may result in damage to the anchor arms, the anchor
attachment point, or the ceiling, which could lead to a falling hazard.
5. Place the input cover over the connector and press it firmly against the loudspeaker to create a tight seal. Use the two
included input cover screws to secure the input cover. See Preparing the Input Cover on page 5.
q
e
t
w
r

Bose FreeSpace FS4CE Specifications

General

Speaker type	Full range
Driver diameter	114 mm
Number of drivers	1
Speaker placement	Ceiling-mountable
Audio output channels	- channels
Impedance	8 Ω
Sensitivity	88 dB
Frequency range	70 - 17000 Hz
RMS rated power	40 W
Peak Music Power Output (PMPO)	160 W
Backlight	No
Certification	UL 1480, ULC-S541 NFPA 70, NFPA 72, CSA C22.1 Section 32 IEC60268-5, CE RoHS
Product color	White
Housing material	Plastic, Steel
Recommended usage	Universal
Suitable for outdoor use	Yes
Connectivity technology	Wired
Operating temperature (T-T)	-25 - 70 °C
Package weight	9050 g
Transformer taps	2.5, 5, 10, 20, 40 W

Weight and Dimensions

Width	272 mm
Height	172 mm
Weight	3470 g