POWER ON/OFF CONTROLS
Sta_ing yeur syste_
Press the power button on the remote or on the
console.
To keep energy consumption to a minimum, the system
operates in a very low power state when in standby (off)
mode. Because of this, the system requires several
seconds to start. The power LED on the console
changes to blinking green while the system starts up.
When it changes from blinking to solid green, your
system is on and ready to use.
Pressing the remote SOURCE button also
starts your system and puts the SOURCE
menu on your TV screen.
Setup Pressing the Setup button on the console
also starts your system and puts the Setup
menu on your TV screen.
Turning on your TV
If you programmed your remote during the initial
setup, press the TV power button on the remote
control to turn on your TV. Otherwise, use the
remote that came with your TV.
Shutting down your system
O ress the power button on the remote or on
the control console. The system will shut down
automatically after a few seconds. However, if
you decide to access the power controls for
connected devices, automatic shutdown will be
stopped and you must complete the shutdown
using the on-screen controls.
6
To Next Page
Loading...
Need help?
General
Weight and Dimensions
