ENGLISH - 21
USING THE SYSTEM
2. Based on your source’s response to basic functions:
• Remote responds accurately: press to exit programming and save your
settings.
• Remote does not respond or does not respond accurately:
– If your source button glows: press on the volume button to move to the
next code. Repeat steps 1 - 2 in “Test your source’s code.” You may need to
repeat this procedure 30 or more times. If all six buttons blink three times, you
have cycled through all codes for your source.
– If your source button is o: your remote exited programming mode.
Repeat steps 1 - 2 in “Enter your source’s code” and steps 1 - 2 in
“Test your source’s code.”
Tip: After you exit programming mode, press the appropriate source button to use
your source.
Note: Your source may not be compatible with universal remote controls or may
not accept IR (infrared) signals. Refer to your source’s owner’s guide for
more information.
Customizing the power button
You can customize (power button) on your remote to power on/o your soundbar,
TV and cable/satellite box simultaneously.
1. Program your remote to control your TV and cable/satellite box (see page 20).
2. Press and simultaneously and hold for 10 seconds.
Both buttons flash three times.
Resyncing your cable/satellite box and TV
After customizing the power button, your cable/satellite box and TV may become out of
sync and not power on/o simultaneously. Use the following steps to resync
your soundbar.
1. Press the source button for the source that is out of sync.
2. Press to power on/o the source.
3. Press .
Your sources power on/o simultaneously.
To Next Page
Loading...
Need help?
General
