Problem
The
dock
does not open
or close properly
No sound
No sound
and
your iPod
is not charging
Your iPod does
not respond
to
the
SoundDock remote
control
OTHER
CARE AND HANDLING
What
to do
• Use a soft, dry cloth
to
wipe the outside
of
the dock, whether it is open
or
closed.
• Blow around the edges
of
the
dock
to
remove any dirt
or
debris from the crevices.
• Increase the volume setting
for
the system.
• Make sure the SoundDock® battery is charged
or
the system is plugged in, your iPod® is turned on, and
a music track is selected and playing.
• Remove your iPod from the dock, wait 5 seconds, then reseat it.
You
may need
to
do
this a few times.
• With another sound device, be sure your iPod is removed from the
dock
and the second device is
properly connected, turned on and set
to
play.
• If the other sound device is connected and playing, press any button on the remote control
to
activate
the system. Review "Playing another sound device" on page
8.
• Unplug the SoundDock Portable system and remove the battery from the
back
of
the system
to
com-
pletely shut off any power
to
it. Then reattach the battery and plug the system
in
again.
• Make sure your iPod is firmly seated
in
the
dock
and the SoundDock Portable system battery is charged
or
the
power
supply is plugged
in
properly.
• Remove your iPod from the dock, wait 5 seconds, and return it to the dock.
• An iPod that has buttons and no click-wheel control does not recharge while it plays and
may
need
recharging.
• If the power supply is in use, make sure the power outlet is functioning properly.
• Unplug the SoundDock Portable system and remove the battery from the
back
of
the system
to
com-
pletely shut off any power
to
it. Then reattach the battery and plug the system
in
again.
• Remove your iPod from the dock, wait 5 seconds, then reseat it.
You
may need
to
do
this a few times.
• Your iPod software may need
to
be updated.
• Try the remote from a different location. If it works there, strong lighting
or
other conditions may be
causing the problem. Refer
to
"Using the remote" on page 7
for
further details.
• Make sure nothing blocks the infrared
(IR)
signal path from the remote to your SoundDock Portable
system. Wipe
off
the small lens on the front end
of
the remote.
• Check the remote control battery
to
make sure the + side is up, as shown on page 10.
• Replace the remote control battery.
• Unplug the SoundDock Portable system and remove the battery from the
back
of
the system
to
com-
pletely shut off any
power
to
it. Then reattach the battery and plug the system
in
again.
Technical
Information
Power
supply rating
Input: 100-240V'"'v 50-60Hz, 1A
Output:
20V,
2A
~
System size and
weight
6.7"H x
12.0"W
x 5.1"D (17.0 em x 30.7 em x 12.8 em)
5.2 Ib (2.4 kg), including battery
11
To Next Page
Loading...
Need help?
General
Weight and Dimensions
