20
Operating Your Wave
®
Radio
Using the Alarms
Function Control panel Remote control
To stop the alarm – Press On/Off. The indicators remain lit.
Or, if you do not press On/Off, the tone alarm shuts off in 30 minutes, the
radio alarm shuts off in 60 minutes.
The alarm automatically resets to repeat daily.
To pause the alarm for 10 minutes – Press Sleep/Snooze or Sleep to have
the radio or tone alarm repeat in 10 minutes. When the alarm is in
both radio and tone mode, press Sleep/Snooze or Sleep to pause the tone
for 10 minutes and turn on the radio. Press Sleep/Snooze or Sleep again to
silence the radio – the tone repeats in 10 minutes.
You can repeat the pause cycle as many times as you want. If you do not
press any button while the tone is sounding, it shuts off in 30 minutes.
To set the volume of the radio alarm – The radio alarm turns on and gradu-
ally increases to the last volume setting used. You can select a volume set-
ting with the radio on or off.
To set the volume of the tone alarm – The tone alarm turns on and gradu-
ally increases to the last tone setting used. You can set a louder or softer
tone by pressing Volume up or down while the tone is sounding.
To use the alarm during a power loss – Press On/Off to silence the alarm.
The backup battery runs the alarm for approximately 48 hours without AC
power. To conserve power, only the tone alarm sounds even if the radio
alarm is selected. Normal operation resumes when power is restored.
Replace the 9V battery after an extended power loss.
Note: The Wave radio does not respond to remote control during a
power loss.
Use the control panel to
operate the alarm dur-
ing a power loss.
Alarm Mode
Alarm
Set
Clock
Set
Volume
Presets
123
456
Tuning
Sleep/Snooze
AUX AM/FM
On/Off
Wave Radio
Time
Alarm
Sleep
Tuning
Station
Volume
Mute
AUX
AM
FM
On
Off
Wave Radio
1
23
4
5
6
Presets
On/Off
On
Off
Sleep/Snooze
Volume
Volume
On/Off
To Next Page
Loading...
Need help?
General
