Insert ear cup entirely through bottom portion
of helmet’s ear opening (take precaution as to
not pull/stretch the wire exiting the ear cup).
(gure 5)
Starting with one side, gently pull pivoting arms
apart to release ear cups. (gure 4)
Insert threaded silver stand-off (on the same
side of the ear cup that the cord exits)into the
hole that is on the strap covering the helmet’s
ear hole. (gure 6)
1900 Weld Blvd. Ste. 140 El Cajon, CA 92020 • 800.440.5904 • gibson-barnes.com
Bring he lower part of the helmet’s ear-hole
opening under the ear cup so that the seam is
sitting between the plastic and foam portion.
(gure 7)
gure 3
gure 5
gure 6
gure 4
To Next Page
Loading...
Need help?
General
