3
English
1. Use iron only for its intended use.
2. To protect against a risk of electric
shock do not immerse the iron in
water or other liquids.
3. The iron's temperature selector
should always be turned to the «min»
position before plugging or unplug-
ging from outlet. Never yank cord to
disconnect from outlet; instead, grasp
plug and pull to disconnect.
4. Do not allow cord to touch hot
surfaces. Let iron cool completely
before putting away. Loop cord
loosely around iron when storing it.
5. Always disconnect iron from electrical
outlet when filling with water or
emptying and when not in use.
6. Do not operate iron with a damaged
cord or if the iron has been dropped
or damaged. To avoid risk of electric
shock, do not disassemble the iron;
take it to an authorized service center
for examination and repair.
Unauthorized repair may cause a risk
of electric shock, injury or property
damage.
7. Close supervision is necessary for
any appliance being used by or
near children. Do not leave the iron
unattended while plugged in or on an
ironing board.
8. Burns can occur from touching hot
metal parts, hot water or steam. Use
caution when you turn a steam iron
upside down, as there may be hot
water in the reservoir.
9. This product is intended for
household use only.
IMPORTANT SAFEGUARDS
When using your iron, basic safety precautions should always be followed, including
the following:
READ ALL INSTRUCTIONS BEFORE USING
1. This is a 1500 watt appliance.
To avoid a circuit overload, do not
operate another high wattage
appliance on the same circuit.
2. If an extension cord is absolutely
necessary, a 12.5-ampere cord must
be used.
Cords rated for less amperage may
overheat.
Care should be taken to arrange the
cord so that it cannot be pulled or
tripped over.
SPECIAL INSTRUCTIONS
SAVE THESE INSTRUCTIONS
4699375_SI6000_NA Seite 3 Mittwoch, 10. April 2002 8:39 08
To Next Page
Loading...
Need help?
General
