Braun CareStyle 1 User Manual

12
Troubleshooting guide
PROBLEM POSSIBLE CAUSE SOLUTION
The iron does not
produce any steam
When starting your ironing session the
steam button has not been pressed
long enough
Press and hold the steam button until
steam comes out. It may take up to
30 seconds until steam comes out
There is not enough water in the water
tank
Fill the water tank
If the «clean» system LED turns on,
the steam function has been disabled
until you have performed the cleaning
process
Perform the cleaning process
(see dedicated chapter)
The iron is heating up
When the temperature control LED
is fl ashing, the iron is heating up;
during this phase the steam function
is disabled. Wait until the temperature
control LED turns permanently on.
The appliance has
switched off
The auto-off mode is activated
automatically when there has been no
steam emission for more than
20 minutes
To switch the iron on again, select a
temperature level. The appliance starts
to heat up again.
The iron leaves a
shine or an imprint
on the garment
The temperature selected is too high
Place temperature selector to level
1 (•) or level 2 (••) or place an
additional layer on the garment
During steam
emission the system
produces a pumping
noise associated
with vibrations
If the water tank is full - this is a normal
working condition
No action required
The water tank is empty
Switch off the system, unplug and fi ll
the water tank. Press the steam button
untill the steam comes out.
Water droplets come
out of the soleplate
Steam condenses into water in the
hose when you use steam for the fi rst
time or have not used it for a long time
This is normal. Hold the iron away
from the garment and press the steam
button. Wait until steam instead of
water comes out of the soleplate
During ironing
white particles
and impurities are
coming out from the
soleplate
Your tap water is very hard
If your tap water is hard we recommend
you use either distilled water or
demineralized water
Impurities of chemicals present in the
water have deposited in the steam
vents and/or soleplate
Perform the cleaning process regularly
even if not required by the system
The Calc-Clean
process is not
starting
The temperature selector has not
been turned to «clean» and the «clean»
button has not been pressed until you
hear an acoustic signal.
Follow the steps shown in dedicated
chapter
Water fl ushes out of
the soleplate
The cleaning process has been
activated accidentally.
Switch off the appliance and unplug.
Put the iron on the cleaning vessel,
switch on and perform the cleaning
process completely ( see dedicated
chapter)
5712812311_IS1012_1014_INT.indd 12 26.03.20 11:39

Braun CareStyle 1 Specifications

General

Brand	Braun
Model	CareStyle 1
Category	Iron
Language	English