Braun EXACTFIT 1 User Manual

6
Memory function
Your ExactFit™ 1 blood pressure monitor will automatically store the
latest measurement. Storing is done automatically after the completed
measurement.
To recall the reading, press and hold the power button
for at least
2 seconds while the unit is switched o. When all the display elements
are shown, release the power button and the screen will show the last
reading with an
symbol.
Battery charge indicator
Batteries almost discharged
When the batteries are approximately 75%
used, a battery warning appears. This icon
blinks 3 times rst when the device is turned
on, then goes to measuring mode. The
monitor will continue to measure reliably, but
new batteries should be obtained.
Batteries discharged—replacements required
When the batteries are fully discharged,
the battery symbol will ash empty along
with 3 short beep sounds as soon as the
device is switched on. You cannot take any
further measurement and must replace
the batteries. Refer to the section called
“Inserting batteries”.
Storage and cleaning
• Do not expose device to either extreme
temperatures, humidity, dust or direct
sunlight.
• The cu contains a sensitive air-tight
inatable bladder. Handle this carefully
and avoid all types of straining through
twisting or buckling.
• Clean the product with a soft, slightly
damp cloth. Stains on the cu can be
carefully removed with a damp cloth. Do
not use gasoline, thinners or similar
solvents. Do not wash or dry clean the
cu. Do not store the product in a place
exposed to direct sunlight or high
humidity.
• Do not drop the device or treat it roughly
in any way. Avoid strong vibrations.
!

Braun EXACTFIT 1 Specifications

General

Brand	Braun
Model	EXACTFIT 1
Category	Blood Pressure Monitor
Language	English