Page 27
Platform Angle Adjustment Instructions
Loosen (turn
counterclock-
wise) to lower
outboard end
of platform.
Tighten (turn
clockwise) to
raise outboard
end of platform.
Platform Angle
Adjustment Screws
Adjustment Screw
Adjustment Allen screws are provided on each side
of the lift platform for adjusting the platform angle.
Turn the adjustment screw clockwise to raise the
outboard end of the platform. Turn the adjustment
screw counterclockwise to lower the outboard
end of the platform. Note: Both adjustment screws
must be adjusted equally. Adjust platform angle
as needed. See Figure T on previous page. Apply
Loctite
®
to adjustment screws following adjustment.
Allen Head
Adjustment
Screw
Allen Head
Stop Block
Floor Level Adjustment:
Check bridge plate posi-
tioning as outlined on
pages 38 and 39 when
adjusting platform angle.
To Next Page
Loading...
Need help?
General
