Page 33
Note: Disassembly required if replacing these items. Apply Light Grease to these components during reassembly.
Multipurpose Light Grease (Lubriplate) is available from The Braun Corporation (part number 15805).
Maintenance and Lubrication Schedule
Use Dextron III transmission fluid. Check fluid
level with platform lowered fully and roll stop
unfolded fully. Fill to within 1/2" of the bottom of
the 1-1/2" fill tube (neck).
Resecure, replace or correct as needed.
Tighten, repair or replace if needed.
Tighten, repair or replace if needed.
Replace if needed.
Tighten or replace if needed.
Replace if needed.
Replace if needed.
See Note below!
Replace if needed.
Correct or replace
Tighten, replace or correct as needed
Replace if needed.
Resecure or replace if needed.
Resecure, repair or replace if needed.
Check to see that the lift is securely anchored to
the vehicle and there are no loose bolts, broken
welds, or stress fractures.
Replace decals if worn, missing or illegible.
Replace antiskid if worn or missing. See Decals
and Antiskid section on pages 70-73
Hydraulic Fluid (Pump) - Check level. Note: Fluid
should be changed if there is visible contamination.
Inspect the hydraulic system (cylinder, hoses,
fittings, seals, etc.) for leaks if fluid level is low.
Remove pump module cover and inspect:
• Hydraulic hoses, fittings and connections for wear
or leaks
• Harness cables, wires, terminals and connections
for securement or damage
• Circuit breaker and solenoids for securement or
damage
Inspect cylinders, flow control valves and hydraulic
connections for wear, damage or leaks
Inspect roll stop cylinder hose assembly (hose,
fasteners, connections, etc.) for wear, damage or
leakage
Inspect parallel arms, bushings and pivot pins for
visible wear or damage
Inspect parallel arm pivot pin mounting bolts (8)
Inspect handrails and pivot pins for visible wear or
damage
Inspect vertical arms, platform fold arm bushings
and platform pivot pin for visible wear or damage
Inspect platform pivot arms, rotating pivot slide
arms, slide support arms and associated pivot pins
for visible wear or damage
Inspect platform pivot arms for detached, worn or
missing unfold springs (non-IB)
Inspect gas springs (cylinders) for wear or damage,
proper operation and positive securement (IB)
Inspect rotating pivot slide arm UHMW slide
bearings (buttons)
Inspect vertical arm plastic covers
Inspect power cable
Mounting
Decals and Antiskid
1 Year
or
1250
Cycles
Repeat all previously listed inspection, lubrication
and maintenance procedures at 4 week or 100
cycle intervals.
Consecutive
4 Week or
100 Cycle
Intervals
To Next Page
Loading...
Need help?
General
