Page 43
Maintenance and Lubrication
Proper maintenance is necessary to ensure
safe, troublefree operation. Inspecting the lift for
any wear, damage or other abnormal conditions
should be a part of a regular service program.
Simple inspections can detect potential prob-
lems.
The maintenance and lubrication procedures
specified in the following schedule must be per-
formed by a Braun authorized service represen-
tative at the scheduled intervals according to the
number of cycles.
NL Series lifts are equipped with hardened pins
and self-lubricating bushings to decrease wear,
provide smooth operation and extend the ser-
vice life of the lift.
When servicing the lift at the recommended
intervals, inspection and lubrication procedures
specified in the previous sections should be
repeated. Clean the components and the sur-
rounding area before applying lubricants.
LPS2 General Pur-
pose Penetrating Oil is
recommended where
Light Oil is called out.
Use of improper lubri-
cants can attract dirt
or other contaminants
which could result in
wear or damage to the
components. Platform
components exposed
to contaminants when
lowered to the ground
may require extra
attention.
Maintenance and
lubrication proce-
dures must be per-
formed as specified
by an authorized
service technician.
Failure to do so may
result in serious
bodily injury and/or
property damage.
Lift components requiring grease are lubricated
during assembly procedures. When these compo-
nents are replaced, grease must be applied during
installation procedures. Specified lubricants are
available from The Braun Corporation (part num-
bers provided on page 44).
To Next Page
Loading...
Need help?
General
