11
Description
1. Measuring cap
2. Jug
3. PrecisionEdge blade
4. Centering pad
5. iTextureControl dial + START/STOP button
6. On/O switch
7. Timer
8. Illuminated touch display
9. Motor base
10. Cord storage (on back side)
11. Lid incl. gasket
12. Tamper
Smoothie2Go blending set consisting of:
13. 2 x 600 ml Smoothie2Go bottles incl.
drinking lids
14. Smoothie2Go blade group incl. gasket
15. Smoothie2Go adapter
Before First Use
Clean all parts before using the blender for the
first time – refer to „Care and Cleaning“.
(A) Using the Jug
When switched on (6) and any container (2/13)
is assembled, MANUAL lights up and the
START/STOP button (5) is flashing, indicating
the appliance is ready to use.
By removing the measuring cap (1), you can
add additional ingredients or liquids at low
speed (Fig. A).
Caution:
• Never attempt to operate the appliance wit
-
hout the centering pad (4)
• Be careful when blending hot liquids in the
jug using the manual mode. Start blending
on speed 1 to avoid possible burns due to
escaping steam and splashes. The maximum
allowed amount of hot liquid ingredients in
the jug is 1500 ml.
• The coupling seat may be hot after running –
do not touch.
(B) Automatic Food Programs &
Texture Modes
First, select one of the 6 automatic food pro-
grams (8) and then select your desired texture
(5) to deliver your preferred consistency. Once
you press START (5), the timer (7) shows the
total blending time and counts down (Fig. B). The
program stops automatically when the count-
down ends. To stop the program in advance,
press any button.
For detailed processing instructions refer to
table I.
Pause
To pause the program press START/STOP (5).
The timer (7) and the dial (5) start flashing indi-
cating the pause mode. To continue the pro-
gram press START/STOP again.
„Hot Soup“ Function
When using the program „soup“ + texture
„smooth“ the blades in the jug reach speeds
fast enough to bring cold ingredients to stea-
ming hot in about 6 minutes.
must not be supplied through an
external switching device, such as
a timer, or connected to a circuit
that is regularly switched on and
o by the utility.
• Do not use the device without any
load in the jug.
• Do not store food or liquids in the
jug.
• Avoid bumping or dropping the
blender when in operation or at
any time.
• To avoid damage, do not fill the
containers past the “max” marking
or scale.
5722310535_JB9042_UI_GB_GCC.indd 115722310535_JB9042_UI_GB_GCC.indd 11 23.06.21 08:3623.06.21 08:36
To Next Page
Loading...
Need help?
General