15
• Using the special cord set (9), connect the shaver or the charging stand (10)
to an electrical outlet with the motor switched off.
• When charging for the first time or when the shaver is not used for a few
months, leave the shaver to charge continuously for 4 hours.
• Once the shaver is completely charged, discharge the shaver through
normal use. Then recharge to full capacity. Subsequent charges will take
about 1 hour.
• A full charge provides up to 45 minutes of cordless shaving time depend-
ing on your beard growth. However, the maximum battery capacity will
only be reached after several charging/discharging cycles.
• 5-minute quick charge is sufficient for a shave.
Charging lights (5)
The green charging lights show the charge status of the batteries (340s:
1 charging light). The green charging light blinks when the shaver is being
charged or switched on.
When the battery is fully charged, all green charging lights (340s: 1 charging
light) shine permanently, provided the shaver is connected to an electrical
outlet.
Low-charge light (6)
The red low-charge light flashes when the battery is running low. You should
be able to finish your shave.
Shaving
Press the on/off switch (4) to operate the shaver (picture).
The flexible shaving foils automatically adjust to every contour of your face
(picture).
Long hair trimmer (2)
To trim sideburns, moustache or beard, slide the long hair trimmer upwards.
Precision setting switch (« » ) (380s only)
For precise handling in hard to shave areas (e.g. under the nose) slide the
switch (3) to the right to position « ». The centre trimmer and one foil will be
lowered.
Tips for the perfect shave
For best results, Braun recommends you follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right angles (90°) to your skin.
3. Stretch your skin and shave against the direction of your beard growth.
98826515_380s_China.indd 1598826515_380s_China.indd 15 10.03.11 09:3310.03.11 09:33
To Next Page
Loading...
Need help?
General
