Bunn Dual TF DBC User Manual

Page 17
PROGRAMMING FUNCTIONS - LEVEL 2 (cont.)
SET NEW RECIPE:
If not using a Smart Funnel
®
(with a sensor coil) and/
or a G9-2T DBC Grinder, the brewer will function as
a standard Bunn
®
Dual™ TF Brewer:
It is possible to operate the brewer without using
a Smart Funnel
®
and/or a G9-2T DBC Grinder. If a
standard funnel, or if a non-DBC grinder is used the
brewer will automatically select a NO NAME coffee
flavor when the
pad is pressed. This means that
no name was read from the funnel's handle.
There are two NO NAME coffee programs that can
be set in the brewer. They are referred to as NO NAME
LEFT and NO NAME RIGHT. The left and right sides of
the brewer can be set up independently of each other.
This includes BREW VOLUMES, BYPASS PERCENT-
AGES, PULSE BREW TIMES, PREINFUSION TIMES
and DRIP-OUT TIMES. The brewer will perform in the
same capacity as a standard Bunn Dual TF Brewer.
The instructions for programming the NO NAME
settings are on the following pages. The same steps
are followed for setting the recipe as those that are
used to MODIFY A RECIPE, beginning on page 18.
Note that when the display reads NO NAME LEFT,
that is when MODIFY should be pressed in order to set
the parameters for the NO NAME LEFT coffee.
Otherwise, press NEXT to display NO NAME RIGHT.
At this point, MODIFY should be pressed in order to set
the parameters for the NO NAME RIGHT coffee.
NOTE: Before beginning setup, insert a funnel into the
left and right side funnel rails, and place a ThermoFresh
®
Server beneath each brew funnel.
P2419
35058 121102

Bunn Dual TF DBC Specifications

General

Brand	Bunn
Model	Dual TF DBC
Category	Coffee Maker
Language	English