Page 38
TROUBLESHOOTING (cont.)
Screen Displayed
Possible Cause Troubleshooting Procedures
1. Water temperature in the tank
does not meet the SET READY TEM-
PERATURE.
1. Brew funnel was not removed
after the previous brew cycle was
finished.
1. Brew funnel was moved out of
position after the brew cycle was
started.
(a) Wait for the brewer to heat to the
proper temperature.
(b) Disable the BREW LOCKOUT
function. See page 10 for proce-
dure.
Remove funnel, check contents, and
insert back into the funnel rails.
OR
Press BREW to start a brew cycle
without removing the funnel.
To resume brewing, correctly posi-
tion the funnel and press BREW
again. The brew cycle will resume
from the point it was interrupted.
OR
Press ON/OFF to terminate the cycle.
35058 121102
To Next Page
Loading...
Need help?
General
