BURLINK
CONNECTIONS
Connecting to the BURLINK interface can be done either with the 9 pin D-SUB connector (RS-232) or with the USB
2.0 connector.
RS-232 configuration: 9600Baud, 8bit, parity: none, 1 stop bit, no hardware handshake
A USB device driver needs to be installed when using the USB connector. System requirements for using the USB
software are either WINDOWS 2000 or WINDOWS XP operating system.
COMMANDS
Following the possible commands to control the integrated amplifier 082 are listed. All commands needs to be sent
in capital letters finished with a “carriage return“ \r .
POWON\r switches the unit on
POWOFF\r switches the unit to standby mode
CD\r activates the CD input
TUNER\r activates the TUNER input
AUX\r changes between inputs AUX1 and AUX2
AUX1\r activates the AUX1 input
AUX2\r activates the AUX2 input
TAPE\r activates the TAPE input
SURR\r activates the SURROUND input
VOLUP\r increases the volume for one step
VOLDN\r decreases the volume for one step
MONITOR\r switches the monitor loop on or off
MONITORON\r switches the monitor loop on
MONITOROFF\r switches the monitor loop off
TONE\r switches the tone control on or off
TONEON\r switches the tone control on
TONEOFF\r switches the tone control off
BASSUP\r increases the bass volume for one step (2dB)
BASSDN\r decreases the bass volume for one step (2dB)
TREBLEUP\r increases the treble volume for one step (2dB)
TREBLEDN\r decreases the treble volume for one step (2dB)
BALANCEL\r lowers the volume of the right channel by one step (1dB)
BALANCER\r lowers the volume of the left channel by one step (1dB)
DIM0\r switches the display brightness to maximum
DIM1\r switches the display brightness to middle
DIM2\r switches the display brightness to low
DIM3\r switches the display to off mode
DIM\r switches the brightness step by step (0,1,2,3,0,1,2....)
TYPE\r shows the type of the unit
VERSION\r shows the software version of the unit
To Next Page
Loading...
Need help?
General
