6
PREPARING YOUR AUTO SPEED BLENDER FOR USE
NOTE: Always ensure the appliance is OFF before plugging in.
• Before you use your Auto Speed Blender, remove all packaging.
• Separate the lid, filler cap and blade from the jar. Wash in warm, soapy water, or top rack in the
dishwasher. Rinse and dry well.
• Place the appliance on a flat surface and do not put anything on top of it.
• Never immerse the motor base, power cord or plug in water or any other liquid.
CAUTION: Blade is sharp. Handle with care.
HOW TO USE YOUR AUTO SPEED BLENDER
• Place Blade into Threaded Jar Bottom.
• Place Locking Sealing Ring into Threaded Jar Bottom, on top of blade. Carefully press and tuck
sealing ring into locking groove.
• Ensure the Locking Sealing Ring is fully and evenly tucked in place and holding the blade assembly
to the threaded jar bottom.
• Install the Blade Assembly onto the Blending Jar or Smoothie Cup by inserting (blade first) into the
bottom of the Blending Jar or top of the Smoothie Cup and turning clockwise to tighten.
• Be sure the Blade Assembly is tightened to the Blending Jar or Smoothie Cup before using.
• Put the ingredients into the Blending Jar or Smoothie Cup.
• When using the Blending Jar, secure the Lid and Filler Cap before placing onto the Motor Base.
• Place the Blending Jar or Smoothie Cup onto the base.
• Plug the power cord into a standard household outlet.
• Turn the Programmed Setting and Speed Dial to desired programmed setting or speed.
• Press Start /Pause, Pulse, or Reverse Pulse for desired function.
NOTE: Always place hand on Jar Lid while operating blender.
USING THE PRE-PROGRAMMED SETTINGS
Your Auto Speed blender contains four PROGRAMMED SETTINGS. These programmed settings vary in
blending speed and duration. Refer to the table below for accurate blending duration.
Programmed settings Blending Duration
DIP 27 seconds
MILKSHAKE 34 seconds
SMOOTHIE 1 minute 8 seconds
FROZEN DRINKS 53 seconds
To Next Page
Loading...
Need help?
General
