⑦
⑥
⑥
⑥
⑤
④
⑥
⑧
⑧
③
②
①
①
p. 8 - Manual FA01007-EN - v. 1 - 10/2017 - © CAME S.p.A. - "Translated original instructions"
GENERAL INSTALLATION INDICATIONS
⚠
Only skilled, qualifi ed sta must install this product.
PRELIMINARY CHECKS
⚠
Before beginning the installation, do the following:
• make sure there is are opening and closing mechanical gate stops;
• make sure that the point where the gearmotor is fastened is protected from any impacts and that the surface
is solid enough;
• set up suitable tubes and conduits for the electric cables to pass through, making sure they are protected from
any mechanical damage.
STANDARD INSTALLATION
1. Gear motor
2. Control panel
3. Transmitter
4. Key-switch selector
5. Flashing light
6. Photocells
7. Junction pit
8. Mechanical gate stops
To Next Page
Loading...
General