17
2. Electrical conditions for LVD (Low Voltage Directive) testing.
Power source: AC 220V ~ 240V 50Hz, 250mA, 10W
Insulation class:
3. Environment Conditions for non-automatic weighing instrument.
This product is intended to be “indoor use”.
Altitude: less 2000m
Temperature range: 10 C 40 C
Maximum RH 80% (31 C), decreasing linearly to 50% RH at 40 C.
Supply voltage fluctuations: 10% of the normal voltage.
Installation category:
Pollution degree:
4. How to connect the power supply
The power switch is located on the left side of the scale. Make sure that the
power switch is “OFF”.
Plug the scale into AC socket and make sure that the socket’s power is within
the scale’s operating range. Turn the power switch “ON”.
5. The socket-outlet shall be installed near the equipment and shall be easily
accessible.
6. Do not pour water directly on the scale. Use the plastic cleaner to clean your
scale.
7. Changes or modifications not expressly approved by manufacturer for
compliance could void the user’s authority to operate the equipment.
; Above statements can be applied to CE marked product.
IEC 417. NO. 5032
IEC 417. NO. 5019
ALTERNATING CURRENT
PROTECTIVE CONDUCTOR TERMINAL
SYMBOL PUBLICATION DESCRIPTION
1. Symbol Description
SPECIFICATIONS FOR CE MARKED PRODUCT
To Previous Page
Loading...
Need help?
General
