Note
●
When [H], [M], and [L] are all flashing
on the display, it means that all
functions are disabled due to
momentary battery power
consumption.
●
Charging Time Guidelines
The table below shows guidelines for
approximate charging times.
Charging Times Required for 1 Day of
Operation
Light Level (Lux)
Approximate
Charging Time
50,000 8 minutes
10,000 30 minutes
5,000 48 minutes
500 8 hours
Times Required to Achieve Next Charge
Level
●
Sunny day, outdoors (50,000 lux)
Dead battery
n
Medium
charge
4 hours
Medium charge
n
High
charge
40 hours
High charge
n
Full charge
11 hours
●
Sunny day, near a window (10,000 lux)
Dead battery
n
Medium
charge
12 hours
Medium charge
n
High
charge
150 hours
High charge
n
Full charge
41 hours
●
Overcast day, near a window (5,000 lux)
Dead battery
n
Medium
charge
18 hours
Medium charge
n
High
charge
243 hours
High charge
n
Full charge
65 hours
●
Indoor fluorescent lighting (500 lux)
Dead battery
n
Medium
charge
256 hours
Medium charge
n
High
charge
-
High charge
n
Full charge
-
Note
●
Actual charging time depends on the
local charging environment.
●
Power Saving Function
Leaving the watch in a dark location for about
one hour between the hours of 10 p.m. and 6
a.m. will cause the display to go blank, and the
watch to enter Level 1 power saving. If the
watch is left in this condition for six or seven
days, the watch will enter Level 2 power
saving.
Power Saving Level 1 :
Digital display goes blank to save power.
Power Saving Level 2 :
Digital display goes blank to save power. All
functions are disabled.
Recovering from Power Saving Operation
Use one of the operations below to exit power
saving.
●
Press any button.
●
Move the watch to a bright location.
●
Trigger auto light by angling the watch
towards your face.
Note
●
The watch will not enter power saving
in the cases below.
ー
While in the Stopwatch Mode
ー
While in the Timer Mode
●
You can enable or disable Power
Saving as required.
l
Configuring Power Saving
Function Settings
●
Note that the watch also may enter
power saving if its face is blocked from
light by your sleeve while you are
wearing it.
Viewing the Face in the Dark
The watch has a light that illuminates the face
for viewing in the dark.
●
To illuminate the face manually
Press (B) to turn on illumination.
●
Illumination will turn off automatically if an
alarm starts to sound.
Important!
●
Frequent use of illumination will run
down the battery.
Note
●
Display illumination is disabled when
any one of the conditions below exists.
ー
Alarm, timer alert, or other beeper
sounding
●
To illuminate the face when Auto Light
is enabled
If Auto Light is enabled, face illumination will
turn on automatically whenever the watch is
positioned at an angle of 40 degrees or more.
Watch Operation Guide 3496
7
To Next Page
Loading...
Need help?
General
