About This Manual
This manual covers the operations of the
watch models described below. When there
are any differences between models,
separate explanations and illustrations will be
provided for each as required.
●
The module number and model name of
each watch is stamped on its back cover.
Module 5459 (Model Name: SHB-100)
Does not have a small 24-hour hand.
Module 5460 (Model Name: SHB-200)
Has a small 24-hour hand.
Note
●
The illustrations included in this
operation guide have been created
to facilitate explanation. An
illustration may differ somewhat
from the item it represents.
Basic Operations
This section provides an overview of the watch
and its operations.
General Guide
Model without a Small 24-hour Hand
Model with a Small 24-hour Hand
A
Hour and minute hands
Indicate the current time in your Home City
zone.
B
Day
Indicates the day in your Home City zone.
C
A / P marks
When configuring the Dual Time setting, the
second hand will point to “A” for a.m. times,
and to “P” for p.m. times.
D
Small hour and minute hands
Indicate the current time in your World Time
(Dual Time) City.
E
Second hand
Indicates the current second in your Home
City zone.
F
C mark
When the watch is connected with a phone,
the second hand points to “C”.
G
F mark
When the watch is connected with a phone
that supports a phone finder function, the
second hand will point to “F”.
H
R mark
When the watch is standing by for connection
with a phone, the second hand points to “R”.
I
Small 24-hour hand
Indicates the current time in your World Time
(Dual Time) City.
Using the Crown
●
Pulling Out and Pushing In the Crown
Before performing a crown operation, you
need to pull it out to the first or second click as
shown in the figures below. Do not pull the
crown with too much force.
First click
Second click
Important!
●
To prevent loss of water resistance
and/or damage due to impact, be
sure to push the crown in to its
normal position after you are
finished using it.
●
When pushing the crown back in,
take care not to apply too much
force.
●
Fast Forward/Fast Reverse
After pulling out the crown, rotating it quickly
in succession in either direction will cause the
hands to move forward or back at high speed.
While the hands are moving forward at high
speed, quickly rotating the crown in
succession again will increase the speed even
further.
●
Stopping Fast Forward/Fast Reverse
Rotate the crown in the direction opposite that
of the ongoing operation or press any button.
Note
●
If you do not perform any operation
for about three minutes after pulling
out the crown, crown operations will
automatically become disabled. If
that happens, push the crown back
in and then pull it out again.
Operation Guide 5459/5460
2
To Next Page
Loading...
Need help?
General
