— 10 —
2. Remove the cushion (1), pull the hammer (2),
and then remove the key from the hammer (3).
3. Insert the edge of the tweezers as shown in part
a of the below figure to remove the key.
1
2
3
a
Seven Pins
Four Pins
1
22
4. Remove eight rubber keys.
5. Remove 32 screws and the key PCB.
*Precautions when assembling the rubber keys
The length of this only one rubber key is different. The numbers of pins on the upper and lower sides
are different. Insert the pins and fix them tightly.
Eight Pins
Three Pins
■ To remove the key PCB
1. Remove two screws and the bracket.
1 2
3