7.18 Vibrato Delay (4EH)
Message Format: BnH 4EH vvH
n: MIDI Channel Number
vv: Value (Note1)
Note1: For information about the relationship between setting values and send/receive values, see the “13.3 –64 - 0 - +63
Setting Value Table” in “IV Setting Values and Send/Receive Values” of this document.
Receive Receipt changes the time it takes until note vibrato starts.
7.19 Portamento Control(54H)
Message Format: BnH 54H vvH
n: MIDI Channel Number
vv: Source Key Number
Receive Receipt of this message first stores the Source Note Number for the next note. When the next
Note On is received, the portamento effect is applied to the note using this Source Note Number as the
pitch start point and the Note On event key number as the end point. If there already is a note being
sounded by Source Note Number at this time, the new note on is not performed and the portamento
effect is applied to the pitch of the note being sounded. That is to say that legato play is performed.
7.20 Reverb Send Level (5BH)
Message Format: BnH 5BH vvH
n: MIDI Channel Number
vv: Value
Transmit Sent when GM tone is selected.
Sent when MIDI setting of Accomp MIDI Out set to ON and when automatic accompaniment is
used.
Receive Receipt changes the reverb send level of the corresponding part.
7.21 Chorus Send Level (5DH)
Message Format: BnH 5DH vvH
n: MIDI Channel Number
vv: Value
Transmit Sent when chorus type is selected.
Sent when GM tone is selected.
Sent when MIDI setting of Accomp MIDI Out set to ON and when automatic accompaniment is
used.
Receive Receipt changes the chorus send level of the corresponding part.
12
To Next Page
Loading...
Need help?
General
Weight and Dimensions
