Using Drawbar Organ Tones
E-53
The table below shows the parameters that can be configured on the drawbar editor screen.
The settings marked with an asterisk (*) in the “Setting Range” column are initial defaults.
• While the drawbar edit screen is displayed, you can change the parameters of drawbar 16' through 1' using sliders D-4 (16')
through D-12 (1').
Drawbar Organ Tone Parameter Settings
Parameter Name Setting Setting Range
Ft16' to Ft1'
(Drawbar 16' to Drawbar 1')
Adjusts a tone’s foot “length” harmonic overtone levels (16' to 1'). 0* to 3
Perc. 2nd
(2nd Overtone Percussion)
When “on”, a percussion sound with 2nd harmonic (2nd) or 3rd harmonic
(3rd) pitch is applied to notes.
*1
oFF*, on
Perc. 3rd
(3rd Overtone Percussion)
oFF*, on
Perc.Decay
(Percussion Decay Time)
Specifies the decay time of percussion sound. A larger value specifies a
longer decay time.
000* to 127
Click
(Click)
When “on”, a click is sounded when a note starts to sound. oFF*, on
Type
(Wave Type)
“Sin” (Sine) is a waveform that does not include noise, while “Vin”
(Vintage) is a waveform that includes characteristic noise of an electric
organ.
Sin*, Vin
DSP On Off
to
Rotary Button Off Value
For information about these parameters, see the items starting from “DSP On Off (DSP On/
Off)” under “Tone Parameter Settings” (pages E-48 through E-49).
*1 Makes sustained tones more lively. A percussion sound is sounded at its strongest immediately after a keyboard key is
pressed, and then gradually decays in accordance with the “Perc.Decay” setting. Though keeping keyboard keys depressed
will continue to sound organ notes, only the percussion sound decays.
CTK7000_03_e.fm 53 ページ ２０１０年７月２６日 月曜日 午前１０時４５分
To Next Page
Loading...
Need help?
General
