E-51
1 USB Client Port This port is used to transmit system data and fi le data (download,
upload) by connecting the Ethernet Cradle to a PC using a USB
cable (DT-380USB-A). The dedicated driver must be installed in
the PC before connecting the Ethernet Cradle to the PC.
2 USB Host Port This port is used to connect a corresponding USB peripheral
device.
3 LAN Connection
Status LED
This LED shows the status of the LAN connection.
Off: LAN cable not connected correctly.
Lit orange: LAN cable connected correctly.
4 LAN
Communication
Status LED
This LED shows the LAN operation status.
Off: No communication.
Blinking: Communication in progress.
5 LAN Port This port is used for connecting the cradle to a PC or hub via a
LAN cable so that system data and fi le data can be transmitted
(uploaded or downloaded).
The special driver software must be installed in the DT-X8.
6 AC Adaptor Jack Connect the AC adaptor (sold separately) here.
7 Power Switch Turns the power on and off.
8 Selector Switch This switch is used to switch between a USB connection and a
LAN connection.
LAN: LAN
A: USB host
B: USB client
9
Power Supply/Data
Communication
Terminals
Power is supplied to the DT-X8 via these contacts.
10 Terminal Detect
Switch
This switch detects when the DT-X8 is seated correctly on the
Ethernet Cradle.
11 Mount Hooks These hooks are used to stabilize the Handheld Terminal when
mounting it on the cradle.
12 Power Indicator
LED
This LED indicates the power status and the mounting status of
the DT-X8.
Off: DT-X8 is not installed.
Green: Power on, DT-X8 mounted correctly.
To Next Page
Loading...
Need help?
General
