E-46
Note
The Stopwatch Mode can indicate elapsed time up to 23 hours, 59 minutes, 59.95
•
seconds.
• D button operation (split, reset) is disabled while hands are moving at high speed
following a reset operation and when transitioning from a split time back to normal
elapsed timekeeping.
Once started, stopwatch timing continues until you press
• B to stop it, even if you
exit the Stopwatch Mode to another mode and even if timing reaches the stopwatch
limit defi ned above.
You can press • B to start an elapsed time operation immediately after entering the
Stopwatch Mode, even if the watch’s hands are still moving to their initial Stopwatch
Mode positions. Note, however, that if the stopwatch was not reset after the last
elapsed time operation, timing will restart from where it was last stopped, and not
from 0.
The
• v Left Dial Hand indicates the 1/20-second count for the fi rst 30 seconds of
a stopwatch elapsed time operation. After that, the hand stops at 0. 1/20-second
timing continues internally after the fi rst 30 seconds, and the
v Left Dial Hand will
jump to the current value whenever B (Stop) or D (Split) is pressed.
To Next Page
Loading...
Need help?
General