113
Other Settings (Set Up)
Procedure
MENU * Setup * Startup
Selecting “On” for Startup causes a built-in startup screen to appear on the monitor
screen whenever the camera is turned on.
Procedure
MENU * Setup * Format
If a memory card is loaded in the camera, this operation will format the memory card.
It will format built-in memory if no memory card is loaded.
• The format operation will delete all contents on the memory card or in built-in
memory. It cannot be undone. Make sure you do not need any data currently on
the card or in built-in memory before you format it.
• Formatting built-in memory or a memory card will delete all protected images
stored there.
• Check the battery level before starting a format operation and make sure it is not
too low. Formatting may not be performed correctly and the camera may stop
operating normally if the camera powers down while formatting is in progress.
Procedure
MENU * Setup * Reset
See page 138 for details about the camera’s factory default settings.
The settings below are not reset.
World Time settings, clock settings, date style, screen language, WLAN password
NOTE
• Resetting the camera does not unpair it from a smartphone (page 89).
• Resetting the camera causes the Airplane Mode setting (page 93) to become “Off”.
Displaying a Startup Screen at Power On (Startup)
Formatting Built-in Memory or a Memory Card (Format)
Resetting the Camera to Factory Defaults (Reset)
To Next Page
Loading...
Need help?
General
