73
Viewing Snapshots and Movies
5. Turn on the camera.
The camera monitor screen will shows a remote controller image. The TV screen
will show a recorded image.
• The contents of the remote controller image will depend on the type of image
that is displayed on the TV screen.
6. Touch the camera monitor screen to perform operations.
NOTE
• Use a HDMI cable with a plug that is compatible with the camera’s HDMI micro
connector on one end, and a plug that is compatible with your TV’s HDMI
connector on the other end.
• Proper image and/or audio output and other operations may not be possible with
some devices.
• Connecting the camera to the HDMI connector of another device can damage both
the camera and the other device. Never connect two HDMI output connectors to
each other.
• Disconnect the HDMI cable when you are not using HDMI output. The camera’s
monitor screen may not operate normally while the HDMI cable is connected.
• Audio is monaural.
• Audio is initially output by the camera at maximum volume. When you first start
displaying images, set the TV volume control at a relatively low level and then
adjust it as required.
• To select the digital signal format, see page 112.
To Next Page
Loading...
Need help?
General
