16
Quick Start Basics
. Using the USB Cable to Charge the Battery
The battery loaded in the camera is charged whenever the camera is connected
directly to a computer with the USB cable.
• Depending on the setup of your computer, you may not be able to charge the
camera’s battery over a USB connection. If this happens, use of the charger that
comes with the camera is recommended.
1. Load the battery into the camera (page 18).
2. Turn off the camera.
Check to make sure that the camera’s monitor
screen is blank. If it isn’t, press [ON/OFF]
(Power) to turn off the camera.
IMPORTANT!
• If you connect the camera to a computer for the
first time after you purchase it while the camera is
turned on, the computer will enter a camera
recognition operation. If this happens, perform the
procedure on page 90 or 99. After the computer
recognizes the camera, turn off the camera.
Monitor screen
[ON/OFF] (Power)
To Next Page
Loading...
Need help?
General
Weight and Dimensions
