35
Snapshot Tutorial
1. In the REC mode, press [2] ( )
once.
2. Use [4] and [6] to select the flash
setting you want and then press
[SET].
• If there are no indicators on the
monitor screen, you can cycle
through the flash modes by pressing [2] ( ). You can turn display
information on or off by pressing [8] (DISP) (page 116).
3. Press the shutter button to shoot.
• For information about Flash Range, see page 142.
Using Flash (Flash)
Auto Flash
Flash fires automatically in accordance with exposure
(amount of light and brightness) conditions.
Flash Off Flash does not fire.
Flash On
Flash always fires. This setting can be used to brighten a
subject that normally comes out dark due to daylight or
backlight (daylight synchro flash).
Red Eye
Reduction
Flash fires automatically. This type of flash can be used to
reduce the chance of redness in the subject’s eyes.
Back lamp
Flashes orange while the flash is charging to
indicate that image recording is disabled.
• You will not be able to take another flash
snapshot until the lamp stops flashing orange,
which indicates that charging is complete.
< indicates the flash will fire.
[2] ( )
Flash
To Next Page
Loading...
Need help?
General
