— 22 —
• NORM 1
With NORM 1, exponential notation is automatically used
for integer values with more than 10 digits and decimal values
with more than two decimal places.
• NORM 2
With NORM 2, exponential notation is automatically used
for integer values with more than 10 digits and decimal values
with more than nine decimal places.
To switch between NORM 1 and NORM 2
Press F9. There is no indication on the display of which
for mat is currently in effect, but you can determine the setting
by performing the following calculation.
1
\ 200 = NORM 1 format
NORM 2 format
• All of the examples in this manual show calculation results
using the NORM 1 format.
kWhen you have a problem...
If calculation results are not what you expect or if an error
occurs, perform the following steps.
1.
F0 (COMP mode)
2.
F4 (DEG mode)
3.
F9 (NORM mode)
4. Check the formula you are working with to confirm it is
correct.
5. Enter the correct modes to perform the calculation and
try again.
5.
–03
0.005
To Next Page
Loading...
Need help?
General
